// Licensed Electrician · Park Slope · Brooklyn
Licensed Electrician
in Park Slope
The brownstone heartland is our heartland. Knob-and-tube assessed honestly, parlor floors renovated without plaster casualties, and landmarked blocks navigated daily — Park Slope is where our pre-war methods were forged.
Park Slope's building stock — and what it asks of an electrician
Park Slope is wall-to-wall pre-war: brownstones from the 1880s–1910s on the side streets, pre-war apartment buildings and co-ops on the avenues, much of it inside the Park Slope Historic District — one of the largest landmark districts in the city. The electrical work here is the full pre-war repertoire:
- Knob-and-tube wiring on some or all circuits in most unrenovated brownstones — assessed by condition, never blanket-quoted. Our K&T guide explains the honest framework.
- 60–100A original service meeting modern ambitions — central air, induction kitchens, EV chargers at the curb cut.
- Owner duplex + garden rental configurations — and the two-meter setup most houses should have.
- Renovation electrical — parlor-floor openings, kitchen relocations, cellar legalizations, coordinated with your GC and the DOB.
Landmark district note: LPC rules govern exterior-visible changes — meter locations, exterior conduit, light fixtures on the facade. We plan electrical work around these constraints so your project doesn't stall at the commission.
What Park Slope calls us for
The local greatest hits: whole-house modernization on a phased master plan, panel and service upgrades (with ConEd coordination), dedicated circuits for window ACs and home offices, recessed lighting in plaster ceilings, Lutron Caseta for no-neutral switch boxes, EV chargers for the curb-cut fortunate, and pre-purchase assessments for buyers entering the market with eyes open.
Park Slope landmarks on our working map
Map & coverage
Park Slope FAQ
Yes — the Park Slope Historic District is part of our daily working territory. LPC rules affect exterior-visible electrical elements (meter placement, facade fixtures, exterior conduit); we plan around them and coordinate with your architect when filings are involved.
A single floor runs $3,000–$6,000; a full 3–4 floor house runs $12,000–$35,000 phased. It starts with an assessment ($300–$550, credited toward work) that maps your actual wiring condition — many Slope brownstones need less than a full rewire.
If you have the curb cut and garage or driveway, yes — a dedicated 240V circuit, DOB permit, and incentive guidance included. Service capacity is checked first; many brownstones need the panel conversation before the charger one.
We're Brooklyn-based — Park Slope emergency response typically lands at the fast end of our 1–3 hour window, 24/7.
Get a free quote anywhere in NYC
Tell us the neighborhood and the job — we'll confirm coverage and give you a written fixed price.
